Autocross MazdaSpeed3 Project #8

Cat-Back exhaust for the MazdaSpeed3

Cat-Back exhaust for the MazdaSpeed3

Today Cara put on her exhaust. She wanted more responsibility on this task and I let her have it. The original exhaust had a split all around the pipe right before the second silencer. We worked together to try and pull it apart at that joint, but even after pulling it out like 2 1/2 inches it still wasn’t apart. And I am pretty sure that even if it had, we were not going to weasel the silencer up and over the rear sub-frame. So I pulled out the saws-all and let her go to town. She was pretty apprehensive. But took it like a champ and cut that bitch apart. At this point, the exhaust came off pretty easily. We also installed those Cobb exhaust hangers I mentioned in an earlier post. They are a bitch to get on. But she made it happen. The job ended up being a lot more work than she anticipated. All I did was help pry on things a little and jack up the car and collect tools. Cara pretty much did the rest on her own. So now when the bumper melts, it’s her fault 🙂

Another pretty flange and hanger

Another pretty flange and hanger

More pretty welds

More pretty welds

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s